PV Powered PVP2000 Specifications download pdf (Page 11)

PV Powered LLC 10 32-29-28-20-306

4. Connect the LINE 2/NEUTRAL wire to the terminal marked ‘line 2/neutral’ inside

the StarInverter.

5. Connect the LINE wire to the terminal marked ‘line’ inside the StarInverter.

6. Ensure all connections are wired correctly and properly torqued. Tighten the

terminal block screws to 0.5 Nm.

Figure 8: AC wiring for the line, line 2/neutral and ground wires.

2.3.c Connecting DC Wires/PV Panels

WARNING: Before proceeding with the DC wiring, completely cover the

surface of all PV-arrays with dark material to avoid the production of electrical

current.

WARNING: Make sure the polarity and the PV panel voltage between the +

and the – cable connectors of the PV panels are correct. Then connect the

panels to the DC terminal block on the power distribution board.

The PV panel open circuit voltage should be at or below the listed voltages in Figure 9

under all circumstances. Each DC input to the DC terminal block must be less than the

voltages listed in Figure 9.

StarInverter

Model

PV Panel Open Circuit

Voltage

DC Input to DC Terminal

Block

PVP3200 AND

2800-XV

500VDC 500VDC

PVP2900 500VDC 500VDC

PVP2000 450VDC 450VDC

Figure 9: PV open circuit voltages.

AC Ground

Line

Line 2/

Neutral

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

No comments

PV Powered PVP2000 Specifications Page 11